辊道价格-辊道-圣霖国际【用心服务】(查看)

特别是输出辊道，过去多采用上述方法对中，但是***近有把辊距缩小的倾向，因而采用后一种斜辊布置方式的辊道正在减少。这是为了在轧制薄规格的带钢时避免使带钢在辊道上因终轧速度高而造成折叠。此外，对于辊道的速度和辊子直径也要充分考虑好。

In particular， the output roller table used to use the above methods in the past， but recently there is a tendency to narrow the distance between rolls. Therefore， the roller table with the latter one is decreasing. to ***oid folding the strip on a thin strip of strip to ***oid the high finishing speed of the strip on the roller. In addition，辊道厂家， the speed of the roller and the diameter of the roller should be fully c***idered.

单独传动辊道为一个电机带动一个辊子。这种辊道结构简单，操纵灵活，维修方便。根据铸坯的断面尺寸计算选择辊子直径和辊身长度，切割区后的辊道辊间距取决于定尺长度。切割前辊道速度与拉坯速度一致，切割后要迅速输送铸坯，辊道速度一般为20～30m/min。

A single drive roller is used as a motor to drive a roller. The roller table is simple in structure， flexible in operation and convenient in maintenance. According to the section size of the slab，辊道价格， the diameter of the roller and the length of the roller are calculated. The roller spacing after the cutting area depends on the length of the length. Before cutting roller speed and casting speed， after cutting to quickly transfer slab， roller speed is 20 ~ 30m/min.

出坯辊道是切割区辊道之后至冷床之前的辊道，由若干辊子组成，快速将切割后的定火铸坯输送至横移区辊道。

紧接着出坯辊道的是横移区辊道，该区辊道接受出坯辊道来的铸坯，将铸坯输送至固定挡板之前，辊道生产，由横移机构将每流铸坯输送到冷床或其他区域。

The billet is before and after cutting roller roller roller and cooling bed， of a plurality of rollers， the rapid fire set after cutting billet conveying roller to tr***erse.

Then a blank roller is tr***ersing roller，辊道， the roller roller to accept a billet， billet before delivery to the fixed baffle， by tr***ersing mechani*** each flow casting billet transporting to the bed or other areas.