reducer生产高性价比的选择,圣霖国际顾客至上

减速机与工作机的安装关系：为了避免工作机主轴挠曲及在减速机轴承上产生附加力，减速机与工作机之间的距离，在不影响正常的工作的条件下应尽量小，其值为5-10mm。

The relati***hip between the reducer and the working machine is: to ***oid the additional force of the spindle and the additional bearing on the reducer bearing, the distance between the reducer and the working machine should be as ***all as possible without affecting the normal working conditi***, and its value is 5-10mm.

在输出轴上安装传动件时，不允许用锤子敲击，通常利用装配夹具和轴端的内螺纹，用螺栓将传动件压入，否则有可能造成减速机内部零件的损坏。

When driving parts are installed on the output shaft, it is not allowed to knock with hammers. Usually use assembly jig and inner thread of shaft end to press the tran***ission parts into bolts with bolts, otherwise, it may cause damage to internal parts of reducer.

减速电机分类：

1、大功率齿轮减速电机

2、同轴式斜齿轮减速电机

3、平行轴斜齿轮减速电机

4、螺旋锥齿轮减速电机

5、YCJ系列齿轮减速电机

Deceleration motor classification:

1. High power gear reducer

2, coaxial helical gear reducer

3, parallel axis helical gear deceleration motor

4, spiral bevel gear reducer

5, YCJ series gear deceleration motor