减速机报价值得信赖 圣霖国际用心服务

允许输入法兰：

不能大于或小于临级减速机的标准尺寸，如减速机PLE80?的标准法兰为80mm,其临级的减速级是PLE60?和PLE120，PLE80?允许法兰不应小于60mm,也不能大于120mm。

Allow input flange

It can't be greater than or less than the standard of the reducer. For example, the standard flange of reducer PLE80 is 80mm, and the deceleration stage of its reducer is PLE60? PLE120, PLE80?减速机与工作机的联接：减速机直接套装在工作机主轴上，当减速机运转时，作用在减速机箱体上的反力矩，又安装在减速机箱体上的反力矩支架或由其他方法来平衡。 The maximum allowable flange should not be less than 60mm, nor greater than 120mm.

减速机的作用

1)降速同时提高输出扭矩，扭矩输出比例按步进电机输出乘减速比，但要注意不能超出减速机额定扭矩。

2)速同时降低了负载的惯量，惯量的减少为减速比的平方。大家可以看一下一般电机都有一个惯量数值。

The function of the reducer

1) reduce the speed and increase the output torque at the same time. The ratio of the torque output to the multiplying and decelerating ratio of the stepper motor output, but we must be careful not to exceed the rated torque of the reducer.

2) speed reduces inertia of load at the same time, and inertia reduces to the square of deceleration ratio. As you can see, general motors h***e an inertia value.

齿轮声辐射特征分析 在选择用不同结构形式的齿轮时，对其特定结构建立声辐射模型，进行动力学分析，对齿轮传动系统噪声进行预先评估。以便根据使用者的不同要求（使用场所，是 否无人操作，是否在城区内，地上、地下建筑物有无特定要求，是否有噪声防护，或无其他特定要求）去满足。减速机行业属于国民经济发展的基础行业，从生活家电到汽车飞机、从生产工具到建筑机械，几乎所有的机械传动系统中都需要使用到减速机。

The acoustic radiation characteristic analysis of gear in the selection of gear with different structure forms, set up the acoustic radiation model to its specific structure, carry on the dynamic analysis, and evaluate the gear tran***ission system noise in advance. In order to meet the users' requirements (use sites, unmanned operati, whether there are specific requirements in the urban area, ground or underground buildings, noise protection, or other specific requirements).